SAP XI Question

[Former Member]

If we have an Idoc number how we can get the po number on the basis of that ?

Mostly we use WE21 to check the port and to know - where the port is pointing to production or testing environment. And suppose we want to change it so that it will point to production then what changes we will do ?

[Former Member]

Hi Sushil,

If you want the PO number from an IDOC number, you can go to WE05, pass the IDOC number and search the PO number inside the IDOC segments.

In WE21 you can create a new Port for your Production environment, and then in WE20 you set the Partner Profiles for the IDOCs to use this new Port. Or you can just use the same Port by changing the RFC Destination to point to your Production environment.

I think your thread is a little off topic for in this forum. It should be in the u201CABAP Development » Data Transfersu201D forum :).

Hope it helps.

Regards,

José Omar