cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to see Planning Area & MPOS in Production after Transporting

Former Member
0 Kudos

Hi all,

We are facing a peculiar problem in production system . We transported Planning books along with Planning areas using the transport connection in administration of DP & SNP .The transports are successful . However we are unable to see the Planning areas & MPOS . We transported 2 planning areas an d 2 MPoS's , am able see one MPOS , but no PA's and other MPOS.

Rather strange is all the relevant macros , planning books , selection profiles etc are visible in the system except for the PA & MPOS

Did any one face the a similar situation . What steps are required to rectify this issue.

Thanks in advance

Regards

Surendra

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi Surendra,

Check through transport organiser (se09) whether the transport is

showing successful.

Check for any errors in transport or any repairs to be done

If you have used the background job for /SAPAPO/TSOBJ, then

check the job log/application logs

Regards

R. Senthil Mareeswaran.

Answers (3)

Answers (3)

Former Member
0 Kudos

The problem was with the number ranges , so repaired teh number ranges & retransported everything . Now all the PA's & MPOS are appearing

Former Member
0 Kudos

No ranges of what?

Thanks,

Bijit

Former Member
0 Kudos

Please check in table /SAPAPO/TSAREAKO whether you have the relation between the PA and the POS.

Former Member
0 Kudos

Surendra,

First check should be to check the detailed logs for the transports from se09. See if there are any error messages/warnin g messages. Its weird that you can access all the related planning books and the data views/macros but not the PA. That emans the PA has been transported.

Are the PB/DVs show teh correct PA asisgnment?

Are they working correctly?

Have you checked there is NO FILTER SET in /sapapo/msdp_admin?

Please check and confirm.

Abhi