on 06-02-2010 12:25 PM
Hi,
I have a problem while replicating the product category from SRM 5.0 to R/4 4.7 system. When I run the load the entry is stuck in the queue and the error message says:
The current application triggered a termination with a short dump.
I have reset the status of the queue and tried to execute it again and it gives me the error as "Function module does not exist or Exception raised".
I have checked St22 and SM21 for any system logs, but could not find any.
Can any one please let me know what could be the possible problem.
Ravi G
Resolved by self
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ravi,
1. Notes to be applied:
720819 read&realize and run job BBP_PRODUCT_SETTINGS_MW
872533 read&realize top 1
1049693 incl. attachement
Customizing:
- Error COM_ATTRFRG_GEN056 is related to settype (GUID) assigned to
categories.
- Please delete erroneous ERP: SMQ1 queue R3A* entries and in
SRM: SMQ2 queue R3A* entries, otherwise follow-on loads would fail
(note 872533 top 1).
- Using ta COMM_HIERARCHY, R3PRODSTYP, MAT_ check if
SetType COMM_PR_PUR_1 exists. If not, create it manually
(confirm raising pop-up).
- Apply note 1049693 and run attached job of the note.
Hope this helps,
Kind regards,
Matthew
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.