RFC Sender CC: Characters get changed

[Former Member]

Hi everybody,

I send a message via RFC from R/3.

Value e.g. is: 123456787890ABCDEFG

In SXMV_MONI I see e.g. S9hkdsfaJhh7j== !

I set the CC to Unicode.

What can I do?

Thanks

regards

mario

[former_member200962]

What about the settings in your RFC destination (unicode or not)?

Regards,

Abhishek.

[Former Member]

Hi Abhishek,

the setting is Non-Unicode. But the checkbox "Communication Type with Target system" on register "MDMP & Unicode" in SM59 is disabled !?

When check the button

Regards

Mario

Edited by: Mario Müller on Jun 2, 2010 1:56 AM

[stefan_grube]

Is your R/3 system unicode or not?

When it is not unicode, set channel properties to non-unicode.

But SM59 has to be unicode as PI always is unicode.

[Former Member]

Hi Stefan,

thank you for the reply.

a) Where can I see it it is unicode or not?

b) Where can I set unicode?

Many thanks

Regards

Mairo

[stefan_grube]

1. SM59 register "MDMP & Unicode".

2. system -> status -> unicode system

[Former Member]

Hi Stefan,

as I wrote to Abhishek:

the setting is Non-Unicode. But the checkbox "Communication Type with Target system" on register "MDMP & Unicode" in SM59 is disabled !?

Could this be because of missing rights?

regards

Mario

[Former Member]

Once u select non-unicode it auotomatically disabled the all the value.But u have to select Change button then all selected values will be enabled mode.then u selct Unicode and save it.

[Former Member]

Hi ravi,

if I select change mode --> Checkbox ist still disabled.

Even if I create a new RFC-Conenction type tcp/ip it is disabled.

Regards

Mario

[stefan_grube]

the trouble shooting guide states, that you need not (cannot) set unicode flag in SM59.

So just uncheck unicode flag in sender channel, that should be sufficient.

[Former Member]

Can anyone tell me where is the sender channel?

Or where is this sender channel?

RC