on 05-31-2010 12:54 PM
Hi
i am having some problem while calling the control charts in result recording screen. for some quantitative characteristics it shows control chart, and when i assign the same characteristic on some other material it just show a single point on chart,(it shows one partial sample when i click on "Display Statistical Value" ) would u plz guide me whers i m doing the mistake. is there any setting in Sampling procedure ,Master insp characteristics or any where else
would u plz tell me what is partial sample???? how could i have more than one (1) partial samples in result recording. as control chart is fully shown when there are more than one partial sample.
regards
What inspection type is your material having? Is it 04?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.