RFC authorisation for S000* user

[nanda_kumar21]

Hi,

We have solman 7.0 EHP1 on Oracle on HP-UX.

During MOPZ config, in the SAPOSS RFC connection,

for the logon information i gave username S000****.

the mopz config was succcessful.

Now i was trying to activate the BC sets in solman_setup.

In the middle of the Basic configuration, wher i have to download the SAP note 1172948.

Now when i click start download, i get the following error

 SAP Note 0001172948 cannot be downloaded
 Error in remote connection to destination SAPOSS: No RFC authorization for user S000xxxxxxx. 

Please help me with this problem.

[Nibu · Accepted solution]

Hi Nanda,

Check SM59 > ABAP Connections> SAPOSS

Check the connection. If this RFC connection works fine, you can download the note .

If any issues with the connection, check your router is running fine and check the entries in Tcode OSS1 > Technical parameters .

Regards,

Nibu Antony

[nanda_kumar21 · Accepted solution]

Hi Nibu,

I did connection and authorisation test on SAPOSS connection, both were succesful

and technical parameters are configured correclty.

[JaredS · Accepted solution]

Have you verified that the username for SAPOSS is set to OSS_RFC and the client is set to 001 as outlined in the note above?

Thanks,

typo above from my last response..meant to type SAPNOTE will use SAPOSS.

[nanda_kumar21 · Accepted solution]

No, i just checked the S-User id i gave (S000*).

Ok, if i give the user -id as OSS_RFC, wont it affect my MOPZ configuration?

[JaredS · Accepted solution]

It will not.

Please see the note for the password as it is very specific to this RFC. Also change the client to 001.

Regards,

Jared

[JaredS]

Hello,

Most likely the issue is caused by a problem with SAPOSS as this is used by MOPZ.

Please review SAP Note 182308 - Incorrect logon data in R/3 destination SAPOSS

[nanda_kumar21]

Thanks for ur reply Mr.Jared Singh.

I checked the SAP note u mentioned and the logon data provided is not changed.

It works perfectly fine!

So wat might be the problem?

[Miguel_Ariño]

Hello,

In order to be able to establish an RFC connection, a user must have assigned the authorizations in authorization object S_RFC.

I guess that the user that you have mapped to the S user in AISUSER does not have the authorizations for object S_RFC.

Best regards,

Miguel Ariñ

[nanda_kumar21]

I have SAP_ALL and SAP_NEW and also S_A.SYSTEM assigned.