Rounding value in PO

[Former Member]

Dear All,

The requirement is to use the rounding value in material master for MRP run only.But for me

System is rounding the value while creating PO. I have give the value 2.5 L in PR but it is showing the round value in PO, PO should not round off the value when a PR for the same material is converted to PO.

With Regards,

Vengatesh.S

[Former Member]

done...

[Former Member]

The rounding value is used in the planning run if no rounding profile has been specified in the material master record. If you maintain the rounding value in Material master the system rounds up the procurement quantity.

Use rounding profile in your case.

[Former Member]

Can you explian fully how to maintaing Rounding Profile.

With Regards,

Vengatesh.S