REG manual valuation pop up window in QA32

[Former Member]

Hi

I need to know how to stop the pop up window for Manual valuation in QA32. When I do RR for any MIC, a manual valuation window comes for accepting/rejecting the MIC.

My basic setting at plant level for result recording configuration is automatic close, I am not using any sampling procedure and No inspection point is being used. Its a raw material with simple MICs and inspection plan.

[former_member662213 · Accepted solution]

Hi,

system asks for manual valuation wherever it does not found valuation mode and valuation mode is defined in sampling procedure.

For that, in MIC,use the control indicator "Sampling Procedure" active. If you activate this control indicator.

Then when you assign the MIC in the inspection plan, the system will ask the sampling procedure, now in that use the sampling procedure which has valuation mode as "Attributive inspection of non-conforming units" or Mean Value within tolerance range".

After that create inspection lot and do results recording, in that case, system wont ask for manual valuation.

Thanks

SUMIT

[Former Member · Accepted solution]

Thanks Sumit!