SLED error in LQUA table after batch to batch transfer posting -

[Former Member]

Hi All,

I have done a batch to batch transfer posting in 309(same material - batch to batch).

At IM level the receiving batch charecteristics have been copied.

When i create a TO from the posting change number using LT05 and check the bin stock status or check LQUA table,the SLED of the receiving batch has the SLED of the issuing batch.

Problem is not with IM stock/WM stock but,only the batch characteristics are not getting copied at WM level.

Please suggest a solution to this issue.

Regards

Deepak

[Former Member]

Creating new batch while posting the change?

Check the config for mvmnt 309 to copy characteristics of source batch

[Former Member]

Hi All,

Stock of the material in IM and WM are as follows

IM sloc - - batch A - 50EA - SLED - 15/5/2010 WM - bin A01 - 50EA

IM sloc - - batch B - 50EA - SLED - 15/10/2010 - WM - bin A02 - 50EA

Scenario is I have done a batch to batch transfer posting of the same material for 20 EA from batch A to batch B in MB1B.

batch charecteristics of the both batches is

After I create a TO from the posting change number.

After the TO creation and confirmation IM stock is

IM sloc - - batch A - 30 EA - SLED - 15/5/2010

IM sloc - - batch B - 70 EA - SLED - 15/10/2010

WM - batch A - bin A01 - 30 EA - SLED - 15/5/2010

WM - batch B - bin A01 - 20 EA - SLED - 15/5/2010 (wrong SLED)

WM - batch B - bin A02 - 50EA - SLED - 15/10/2010

Can someone suggest if there is any configuration settings or this is s standard system behaviour.

Regards

Deepak

[Former Member]

Standard behavior, system calculates total shelf life from manufacuring date (or GR date if left blank) entered in Good Reciept doc. from material or batch life entered in master data

batch change would not update manufacturing date from goods reciept