on 04-28-2010 8:35 AM
Hello experts,
after the system copy I want to finish with the follow-up activities. And there is also a point,
where I should change the connection in the exchange profile.
But if I change the connection, following message appears: Client 010 is not available in this system
Any idea, what did I forget to do?
Hoping for help,
Barbara
> after the system copy I want to finish with the follow-up activities.
I forgot to ask you, which system copy you have done? Is it of R3 or XI? Because I replied considering the copy of R3.
If this was a copy of XI system itself and now you want to use client 001 instead of 010 then in exchangeProfile click on "Connection" Tab and change the client.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You have to basically look and do the changes at below mentioned areas
1. Check in client 010 by using tcode SLDAPICUST is it points to you XI system
2. Cheeck in client 010 by using tcode SXMB_ADM and see if this system has been set as your Application Server and also the RFC destination points to XI server.
Regards,
Sarvesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sarvesh,
thanks for your answer. The problem is, that I do not want to use client 010 as
host for my exchange profile. I want to use client 001.
I checked the data of SLDAPICUST in both of my clients - it points to the SLD
I also checked the SXMB_ADM
Which RFC-destination points to XI exactly?
Any other ideas?
Thanks a lot,
Barbara
User | Count |
---|---|
81 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.