on 04-15-2010 5:58 PM
We have R/3 System which is 4.7 Non-Unicode. We are not using MDMP and only have single code page. Can I upgrade directly to Non-unicode version of ERP 6.0 EHP4 or do I need to use CU & UC. I read some where that EHP4 cannot be used on Non-Unicode versions.
Hi *
I've been reading this thread and our scenario is that we have three years ago upgraded from 4.6 to ECC 6 and now would like to go to EHP4 or 5 on a NUC system.
I have read that ramping up to EHP4 can be done on a NUC system is this true?
Secondly should we go to EHP5 is can we still use a NUC system?
Regards
Maahir
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
> do I need to use CU & UC
You don't have to do unicode conversion, kernel 70x has non-unicode version.
> Can I upgrade directly to Non-unicode version of ERP 6.0 EHP4
You cannot directly upgrade to or newly install an ERP 6.0 with EHP4, instead you need to upgrade to ERP 6.0 and then use EHPI to install EHP4.
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
78 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.