Maintenance optimizer configuration on EHP1 solman 7.0

[Former Member]

Dear All,

I just installad Solution Manager EHP1

i am trying to configure the Maintenance optimizer, but not getting the idea where to start from.

i configured in solma4.0 that worked fine but for EHP1 not sure how to start and from where to start,

kindly advise.

Regards,

Irfan..

[Former Member]

Hi, Irfan,

use t-code solman_setup,

when initial setup and basic setup all finished , your maintenance optimizer will work.

Enddy.

[Former Member]

Hi,

Solman_Setup Tcode opens browser but shows nothing..

no error message displayed in the browser,

do i need to do any prerequisities...

thanks

IRfan

[Former Member]

Hi,

Please review the information I sent to you above. Also, you need to have your basic settings completed, specially for your HTTP settings. This is probably your problem right now. You can get this done via SPRO.

Thanks,

Mark

[RajeevP]

Hi Irfan,

Please start from SPROSAP solution ManagerBasic settings--Maintenance optimizer.

Rajeev

[Former Member]

Hello Irfan,

Please go to this URL which should have lots of valuable information for you to be able to start configuring your maintanance optomizer on Solution Manager 7.0.

http://service.sap.com/mopz

Also, please check the following SAP note which should answer many of the questions that you may have on mopz:

1333704 - FAQ: Maintenance Optimizer

Hope this helps you out!

Thanks,

Mark