Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

Configuring IDOC to file Scenario in PI 7

Hello All,

I am doing an IDOC to file scenario, all the configuration is done. When i trigger the outbound IDOC, I can see in SXMB_MONI the sender component, sender Namespace, sender interface and reciever component are coming up correctly as configured.

1. But the reciever namespace and Reciever Interface are having the same values as the sender namespace and sender interface interface respectively. I am sure they have to be as per the config in ID.

2. Also on further going into the error message

SAP:Code area="OUTBINDING">CO_TXT_OUTBINDING_ERROR</SAP:Code

SAP:AdditionalText>No standard agreement found for , DEV400, ANZ, BC_RECV_PAYM_ORD, urn:sap-com:document:sap:idoc:messages, PAYEXT.PEXR2002</SAP:AdditionalText>

Can anyone please suggest , what is it that I am doing wrong.

---Prashanth

Former Member
Former Member replied
<body><p>Hi Prasanth,</p><p></p><p>Can you please look at this &#91;blog|http://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/5696&#93 <b>[original link is broken]</b> <b>[original link is broken]</b> <b>[original link is broken]</b>; ,the extract is below</p><pre __jive_macro_name="code"><![CDATA[ Error Category - CO_TXT_OUTBINDING_NOT_FOUND The problem is in Technical routing. Check whether the receiver determination and interface determination objects are active in change lists tab. If they are not active, activate the objects. Also check the if the receiver determination and interface determination objects are referenced to the same namespace or not. Sender and receiver interface objects should always refer to the same Namespace. ]]></pre><p></p><p>Regards,</p><p>Srinivas</p></body>
0 View this answer in context
Not what you were looking for? View more on this topic or Ask a question