on 04-13-2010 12:14 PM
Hi,
I got the following error while creating rough cut planning profile for Info structure,
Capacity planning is not possible for this info structure S504
Message no. MA489
Diagnosis
In the planning parameters for info structure S504, no key figure for capacity planning has been entered.
Procedure
If you want to capacity planning to be possible for this info structure, you need to enter a capacity key figure in the planning parameters for the info structure in the Implementation Guide.
The info structure which i used here is created by me. Can any one help me to overcome this error
Waiting for your replies
G.Muthamil Murugan.
Dear
Please check the below points.
1) in MC21 transaction while creating Info structure, have you assigned the Key Figures?? if not assign the key figures.
If yes then check the below.
Check transaction MC7F(Planning Parameters) for that particular Info structure in field Capacity Figure enter the Key Figure for capacity Planning.
Please check the above and get back to me.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi addy,
Thanks for your reply. I have maintained the following Info structure which I created,
Under characteristic I have maintained the following,
1.Sales Organisation.
2.Sales group
3. Sales office
4. Distribution channel
5.Division
6.Material
Under Key figure I have maintain the following,
1. Order items
2. Production
3.Sales
4. Stock level
5. Target stock level
6. Day's Supply
7. available capacity
8.Target days supply
I don t know where i did mistake. can you correct me.
Regards,
Muthamil Murugan.G
Hi Muthamil
You have created the Info Structure, you have assigned the characteristics (Levels of an organization for which you are planning) and key figures ( Production plan, Sales plan) and that have you generated the same and saved??
Now the next step you have to execute T.Code : MC7F(Planning parameters), select the Info structure(S504) created above and select the Planning Method, then the planning units tab and coming to the System parameters tab in Capacity Figure field input Production Key figure (based on your requirement).
After completing the above, try creating the rough cut planning profile it should work.
Please check and revert.
User | Count |
---|---|
91 | |
8 | |
7 | |
4 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.