Target quantity calculation in Production order.

[Former Member]

Hi Freinds,

Target quantity of the components to be issued is calculated from the ratio from BOM of header material.

If there is component scrap for the components mentioned in BOM then the Target quantity calcultion also considers this and increases the quantity by the Scrap percentage mentioned.

Target quantity gets updated at the time of goods issue during confirmation

Problem is only for orders of one material, the target quantity calculated of components is not considering scrap inspite of maintaining the scrap for components in BOM.

Can anybody help in this matter, what could be the missing setting ?

Thanks in Advance

Shailesh

.

[Former Member]

Hi Shailesh,

Please check whether the BOM where u maintained the scrap is being copied to the order. To my knowledge there is no other settings required to consider component scrap.

I think the BOM which is copied to the order might be of different alternative BOM where you have not maintained the scrap for that particular component.

Please check and revert.

Regards

Suri

[Former Member]

i am closing this thread

Shailseh