Changes in Logistics DataSource Extract Structure

[Former Member]

Hi All,

We intend to transport our enhanced extract structure of our Logistics DataSource. We know that extraction queue and delta queue must be emptied first before the transport starts.

However, we are wondering whether a re-INIT of delta also must be done or not. At this moment, we have delta up and running already.

Please advice. Thanks.

[Former Member · Accepted solution]

Hi Reddy,

Thanks for your fast reply.

No, we don't need that historical data. Perhaps, to be more specific, we are wondering whether a Re-INIT without data transfer should be done again or not ?

We have two cubes. One is old one with up and running delta. The other is new one which we are going to transport soon.

So, we plan to use same delta infopackage later for these two cubes.

The concern is now about the delta.

Please advice again. Thanks.

[Former Member · Accepted solution]

Hi Handoko,

No, we don't need that historical data. Perhaps, to be more specific, we are wondering whether a Re-INIT without data transfer should be done again or not ?

NO need: If the Business doesn't need historical data and only needs the delta, then no need to do reinit.

After the transports just start the V3 job gain and pull the deltas.

Regards,

Reddy

[Former Member]

Hi

However, we are wondering whether a re-INIT of delta also must be done or not. At this moment, we have delta up and running already

Answer is yes: If your business requirement is to have historical data for the enchaned fileds then you should do re init and then followed by deltas.

Please make sure to clean up the delta queues before transports and stop v3 job for that appilication .

Hope this helps.

Regards,

Reddy