internal order posting error

[Former Member]

hi,

I have just configurated internal order. But when I tried to post document in fb50 or fb60 with internal order number, i got the following error;

What happened?

The current application program detected a situation which really

should not occur. Therefore, a termination with a short dump was

triggered on purpose by the key word MESSAGE (type X).

What can you do?

Note down which actions and inputs caused the error.

To process the problem further, contact you SAP system

administrator.

Using Transaction ST22 for ABAP Dump Analysis, you can look

at and manage termination messages, and you can also

keep them for a long time.

when i refer to ST22 and how to correct the error the messege is as follows;

If the error occures in a non-modified SAP program, you may be able to

find an interim solution in an SAP Note.

If you have access to SAP Notes, carry out a search with the following

keywords:

"MESSAGE_TYPE_X" " "

"SAPLKAID" or "LKAIDF0B"

"MESSAGE_SEND"

Can you please manage me to solve the problem?

[Former Member]

Did you ever find a solution to this, as I am encounting the same issue?

Thanks!

[Former Member]

Hi,

Patti,

Not yet. If i would find solution i will explain here but if you will first find it you will explain here.

good luck.

[Former Member]

Hi,

We noticed this issue with closed order. System does not give an internal order closed error message insted it dumps.

Thanks

Vaibhav

[Former Member]

Hi,

If it is the case, how can i overcome the problem?

[Former Member]

Hi,

Take a look at OSS note 1361352. Check for both correction instruction and based on the SAP release you can decide which one to import.

Thanks

Vaibhav

[iklovski]

Hi,

What SAP version you are using?

Regards,

Eli

[Former Member]

Hi Eli,

It is ECC 6.0

I would really appreciate so much for helping.

Thanks in advance.

[Former Member]

HI,

any message number information (Message number KI xxx) for this short dump?

Check SAPNET note 370250, maybe the trace described there is helpful.

best regards, Christian

[Former Member]

Thanks for your reply

there is no any massage numbers, I could not find any solution yet with SAPNET note 370250.