missing qty

[Former Member]

Hi, prod order requirements of raw materials is like 0.56 ea etc and in co24- missing parts list, it shows as 1 ea for the same material. Pls advise where to make the setting it shows the exact qty as in prod order?

[Former Member · Accepted solution]

Hi,

Check in T Code CUNI what decimal places is given for unit of measure EA in your system.

If no decimal has been given then system will do always round figure for QTY

Regards

SANIL

[former_member196530]

Dear ,

To address this issue please Go to SPRO>SAP Netweaver >General Settings> Check Units of Measurement, then click on "Units of Measure" (T.Code: CUNI) and Select your Unit of Measurement and go to details put number 4 "Decimal Places" field (you can put 0 to 14 decimal places.

the field domain for QTY field has 3 decimals, you cannot enter more than 3 decimals for a movement.

Regards

JH