BR0243W Wrong creation date 2000-01-01 00.00.00 for volume PRDTPBKP

[former_member214873]

BR0280I BRRESTORE time stamp: 2010-04-07 12.32.32

BR0226I Rewinding tape volume in device /dev/rmt1 ...

BR0351I Restoring /oracle/QAS/sapbackup/.tape.hdr0

BR0355I from /dev/rmt1.1 ...

BR0241I Checking label on volume in device /dev/rmt1.1

BR0243W Wrong creation date 2000-01-01 00.00.00 for volume SCRATCH in device /dev/rmt1.1

BR0218W Checking label on volume in device /dev/rmt1.1 failed

BR0212I Please check the volume or the device

BR0280I BRRESTORE time stamp: 2010-04-07 12.36.20

BR0256I Enter 'c[ont]' to continue, 's[top]' to cancel BRRESTORE:

[Former Member]

HI Sudheer,

I am also facing the same issue while restoring. Kindly give the solution at the earliest.

Thanks in advance.

Thanks & Regards,

Arpan

[usman_ahmad]

Have you already remounted the tape as the warning message indicated?

Please also see SAP note 35974

#35974 - BRRESTORE: Termination with error message BR243E

[JPReyes]

Wrong creation date 2000-01-01 00.00.00 for volume SCRATCH in device /dev/rmt1.1

BRRESTORE / Volume SCRATCH?...

I presume you are trying to restore data... in that case you have probably inserted the wrong tape as usually when a tape labeled SCRATCH is used to replace a defective tape in a cycle is relabeled with the requested tape label during backup.

Can you please describe your scenario in detail?

Regards

Juan

[former_member214873]

we performing system refresh from production to quality

and we are BRRESTORE command

[former_member204746]

the tape your inserted is BLANK.

you did not backup on it or you erased it after backup.

go get a tape with a valid backup and try again.

[former_member214873]

yesterday itself full online database backup performed by DB13.

now we trying to restore the backup from tape

[Former Member]

And you didn't by any chance label or initialize this very tape in meantime ??

[former_member214873]

volume label name given was PRDTPBKP

[JPReyes]

volume SCRATCH in device /dev/rmt1.1

Clearly states that the tape in the drive is BLANK... if it was used the SCRATCH label would have been overwriten.

Regards

Juan

[former_member214873]

i given volume label PRDTPBKP

i am having problem with time and date not with volume label

when brrestore

[former_member204746]

there are 2 kinds of label,

1. the one you stick on the tape cartridge.

2. the software label.

Brrestore checks the second one, the software label... obviously, it cannot read the "sticky label"...

brrestore tells you that you software label is SCRATCH and not PRDTPBKP.

you want proof of that?

run this command:

brbackup -i show

you will see SCRATCH.