on 04-07-2010 1:22 PM
Dear all
We have marked MIC as SPC characteristics and results are recorded for same
now we are not getting standard deviation and cp and cpk value in report as it is standard report it should show below value
if there some setting required plz suggest.
Hi,
If the parameter, has control indicator as " Single values". Then only Cp and Cpk value will come.
Thanks
SUMIT
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If you run the report and you are seeing something like *** then I suspect it is for the following reason which is provided by SAP in the F1 help if you click on the Cp value field after displaying the report. A
From SAP F1 help:
Note
If there is neither a master inspection characteristic, nor an
inspection characteristic in the drill-down, the cp value does not have
an influence. In such a case, the system issues asterisks (***) instead
of the cp value. Similarly, if there are no tolerance limits, the system
issues asterisks (***) instead of the cp value.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
11 | |
11 | |
6 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.