on 04-06-2010 5:22 AM
Hi,
I want to enter results for 4 samples for a MIC in an inspection lot. For this i created a sampling procedure with fixed sample: 4 and valuation mode: 700 - Mean value with tolerance range in ECC 6.0 system and assigned it in Inspection plan for a MIC of Quantitative char. (lower/upper tolerance), LongTerm, Single results, Required char., ScpNotFixed.
But after this, i am not able to enter results for 4 ...as it shows only one Sample Size that Has to Be Inspected for a Characteristic in the inspection lot.
Could you please tell what is wrong in this?
Thanks in advance for ur quick response.
Regards,
Senthil Kumar A
make sure that char is not optional char in control indicator
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks for your reply.
Currently, the sample qty for that MIC in Inspection plan is same as Base qty of the operation. For example: 1 KG - both Base qty and sample base qty.
When I changed the sample qty to 0.01 KG, i could see 4 samples to be inspected in the lot.
I don't know the reason behind this.
(Note: The char is an optional char. In this case, what would be the impact?
and there is no inspection point assigned and no sample management active in sampling procedure)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi ,
in inspectaion plan did u give the inpection points 200 ?
also check whether you have activated sample management in sampling procedure?
regrds
satish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.