How to create an IBASE?

[Former Member]

I go to txn IB52 and see no any IBASE defined.

Could you tell me how to create an IBASE using txn IB51 for CHARM project?

In my previous project , there were some IBASEs existing already so I used them as granted.

Thanks a lot!

We are SM7.0 Basis SP16, ABAP SP16. Thanks!

[prakhar_saxena · Accepted solution]

Hi

This is master data so you have to do it as per below

Create the Component Systems and Assign as iBase Components

Use

To be able to use the Service Desk, Change Request Management, or Issue Management scenarios in SAP Solution Manager, you must first define the installed base (IBase). An IBase component must be created for each component system used to send Service Desk messages to the SAP Solution Manager system.

You can generate the IBase specific to a solution or across all solutions.

Requirements

You have defined your system landscape in the Solution Manager System Landscape.

Default Settings

When you create new system or change existing systems in the System Landscape Maintenance (transaction SMSY), the system automatically creates the corresponding IBase component.

Activities

A) Solution-specific

1. Choose the relevant solution from the solution overview.

2. Choose Edit -> Initial Data Transfer for IBase.

The IBase components are automatically assigned to the installation SOL_MAN_DATA_REP (external ID).

Choose the relevant system(s) from the list and confirm.

The data is automatically retrieved from the System Landscape Maintenance (transaction SMSY). The system creates an IBase component for each entry. The IBase components are automatically assigned to the installation SOL_MAN_DATA_REP (external ID).

Moreover use the tcde IB_GEN to geneerate cross solution

Hope prb is solved

Regards

Prakhar

Edited by: Prakhar Saxena on Mar 30, 2010 8:49 PM

[Former Member · Accepted solution]

Thanks a lot!

I did exactly as you said several time but all failed with following error:

No IBase generation data

Message no. DSWP347

Please help. Thanks again!

[sunny_pahuja2 · Accepted solution]

Hi,

Have you defined your system correctly in SMSY ? Because when you define system in SMSY and create RFC in each system for all clients, it will generate IBase number there. Then you can define it in IB52. So, please check it.

Thanks

Sunny

[Former Member · Accepted solution]

I have checked every RFC for this project : client 101(DEV), 102(QAS), 103(PRD). All RFC tests are green.

However the Solution Manager client (100) has no RFC generated, Should I generate the RFC for client100?

Thanks a lot!

[sunny_pahuja2 · Accepted solution]

Hi,

This is fine if RFC's are working and generated.

Check SAP Note 1144386 - Runtime error NO_BP w/ IBase generation

Thanks

Sunny