on 03-27-2010 8:58 AM
Hi,
There is a stock inconsistency between inspection stock in materials management and inspection stocks managed in inspection lots.Due to this, unable to clear inspection stock. I tried with QA08 ,MB1B also assiging inspection type 08 but still posting not happening fron inspection stock to unrestricted stock.
Regards,
Ravi
Hi,
Please refer to SAP Note 48815 - Checking possible inconsistencies between MM and QM.
Create report ZQEVAC20 with code given in sap note.After execution of report systen will clear stock for inconsistency between inspection stock in materials management and inspection stocks managed in inspection lots.
Regards,
Sanjay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ravi,
Please note / clarify following :
1) If in material master of QM you have activated post to inspection (no lot generation with 01 or 04 type insp) then stock will appear in quality, and you should or can only clear it using MB1B 321 movement type.
2) If already you have activated 01 or 04 or 08 then you will be allowed to post stock through inspection only (QA11).
3) Check one more important point :
From old lots somebody might have done result recording and given UD but forgot to do stock posting. you can find such lots with status 'SPRQ'. go to QA32 put particular material, remove range dates and select all insp lots. from the list apply filter to column 'system status' check for ' SPRQ ' in the filter. you will lots where UD given (green radio button) but stock posting pending.
Please elaborate if problem if not resolved.
Best Regards,
Shekhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.