cancel
Showing results for 
Search instead for 
Did you mean: 

WM Inventory

Former Member
0 Kudos

Guys,

Our requirement is that we have to perform a 562 on a non serialized material assign a serial number profile and perform a 561 to put it back to stock with a serial number.

So when we do a 562 in IM a negative quant in 998 Delta is created.On performing a 561 a positive quant is added to 998 Conv

So the issue is currently the system is not configured for auto TO creation and confirmation.If we set this up the negative quant and psoitive quant get cleared out automatically from LS24

If we set up auto TO creation and Confirmation we need to setup a putaway strategy for 561 if the materials are not in fixed bins.We do not want to perfom any config changes right now.

So we decided to perform an immediate 562 and 561 in IM and then create a manual TO using LT01 movement type 999 and balance out the stock from 998 Conv to 998 Delta.

So my questions are what is the optimal solution for this situation?

Can we eliminate the creation fo negative and positive quants during 561 and 562 in 998 dynamic bins so that we do not have to create the manual TO using mvt type 999?

Thanks in Advance

Kiran V Yarlagadda

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

nvm

Edited by: jacobzzz on Mar 19, 2010 9:39 PM

Former Member
0 Kudos

I do not believe the serial numbers can be added another way (without creating the pos. neg. scenario)

Perhaps LT10 can simplify the manual t.o. creations if you do not wish to make the system create t.o.

Answers (0)