Hide initial load image on ITS service

[Former Member]

Hi gurus,

I've defined several ITS services (with properly parameters, webgui, generatedynpro, webgui_simple_toolbar) and used on IAC iviews. All run good, but when I run them, an initial load image (SAP Netweaver, SAP GUI for HTML, SAP Integrated ITS ,...) appears for two or three seconds and then show service. I would like to hide this image. Is it possible?

I'm using ECC 6.0 (SAPKB70020).

Best regards.

[former_member194364 · Accepted solution]

Try adding the parameter ~nosplash 1 to the service parameter settings.

See note: 1236062 SAP GUI for HTML: Parameter ~nosplash

[former_member316351]

OPPS, looks like it's been answered with the correct info....

Edited by: Edgar Chuang on Mar 15, 2010 12:40 PM