Questions about 1003051 - TDMS 3.0 corrections - Composite SAP Note

[Former Member]

Experts:

We, from a big SAP shop, want to set up TDMS for ERP, BI, HCM and CRM.

We have some questions about note 1003051:

1) Is this note about ERP (and HCM) only? If so, what are the notes for TDMS on BI and CRM?

2) Should we apply this note to all systems involved: sender, controller (SM7.0 in our case) and receiver?

3) We have enhp1...enhp4 in our ERP (and HCM), enhp1 on BI and perhaps enhp1 on CRM (not sure yet).

a) What is the impact of enhp on TDMS?

b) should we install TDMS before applying enhp OR the sequence does not matter?

Thanks for your help!

[Former Member · Accepted solution]

1) Is this note about ERP (and HCM) only? If so, what are the notes for TDMS on BI and CRM?

>This is a composite note, and contains information about various other notes related to TDMS. Refer to each note mentioned in this note individually to assess the same.

2) Should we apply this note to all systems involved: sender, controller (SM7.0 in our case) and receiver?

>Depends from note to note, Each note contains the necessary information about the system it has to be installed on.

3) We have enhp1...enhp4 in our ERP (and HCM), enhp1 on BI and perhaps enhp1 on CRM (not sure yet).

a) What is the impact of enhp on TDMS?

>TDMS in standard supports Basis 7.0 systems. However it generally works fine with 7.01 too.

b) should we install TDMS before applying enhp OR the sequence does not matter?

>As TDMS 3.0 is only available for systems with basis 4.6C to 7.0. So install TDMS first and then the EHP.

I hope these answers help.

Regards

Pankaj.