on 06-15-2006 3:16 PM
Hi friends
i created a IDoc using the Link
SAP Menu->Tools->Bussiness Communiation-> IDoc Basis -> Test -> Test Tool
I selected an Idoc of Type MATMAS
and clicked Standard Outbound Processing , i gave the receiver port , Partner Type(LS) and Partner No. this port is basicall connecting to XI system , and my intention is to send an MATMAS Idoc to XI .
But once i click Standard Outbound Processing , it throws a dialog saying <b>" Idoc 00000000001900024 was saved but cannot or should not be sent"</b>
what might be the reason . kindly reply if you know how else do i send a MATMAS IDoc fro R/3 to XI
Hi,
have a look at this weblog first:
/people/prateek.shah/blog/2005/06/08/introduction-to-idoc-xi-file-scenario-and-complete-walk-through-for-starters
it shows how to post an idoc to XI
you need:
1. WE20 (for matmas) in your R3
2. rfc dest to XI from your r3 (SM59)
3. TCODE IDX1 in your XI with parnter number
also have a look at dosuments section
on the XI FAQ page (below)
for many idoc weblogs
https://websmp207.sap-ag.de/~sapdownload/011000358700001410142005E/Configure.pdf
Regards,
michal
-
<a href="/people/michal.krawczyk2/blog/2005/06/28/xipi-faq-frequently-asked-questions"><b>XI / PI FAQ - Frequently Asked Questions</b></a>
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rohit,
DId you have partner profile correct partner Profile configured ? i,e Outbound parameters in WE20 in R/3
In this Outbound parameters, make an entry for your Idoc type.
Also check the Port etc.
Hope this helps,
regards,
Moorthy
Message was edited by: Krishna Moorthy P
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
82 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.