on 03-08-2010 2:22 PM
How can you do if you like to have different inspection characteristics for different (freely-defined) inspection points. E.g. if you take a sampl (sampl 1) by using freely-defined inspection ponits and test 5 differnt MICs, then 10 minutes later you pick another sample (sampl 2) out of your production and there you only need to inspect 3 MICs. How can you set this up?
Hi ,
Better create different operation in routing & then assign different MIC s to different to operation .I think that will be better option
( Aster 5 mins you are going to check only 2 MIC then that will be 1 opoeration ,Then after 10 mins you are checking 5 MICs then that will be 2 nd operation like wise you can check & take result of different sample at different stages.
Regards
SANIL
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Can anyone come up with another idéar that you can have different characteristics to test in different stages in the production with freely defined insp. points.?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You can't.
The only thing you can do is to make all the characteristics as optional characteristics and then just record against the ones you want to do.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
109 | |
15 | |
10 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.