dynamic configuration lost in BPM

[Former Member]

Hi,

My scenario : File->BPM(with several transformation steps)->File.

I would like to use the the dynamic configuration to have the sender Directory and FileName on the receiver side.

The dynamic configuration segment in the SOAP Header is "lost" after the BPM.

Do you know why?

Thanks,

Bela

[moorthy]

Hi,

Are you using Adapter Specific Properties in the Sender Side for the file adapter?(SP 14 and above)

If so , did you do the mapping to get these info into the payload to transfer this data in the receiver side.

/people/michal.krawczyk2/blog/2005/11/10/xi-the-same-filename-from-a-sender-to-a-receiver-file-adapter--sp14

<i>

The dynamic configuration segment in the SOAP Header is "lost" after the BPM.</i>

>>Can you tell more on this

Regards,

moorthy

[Former Member]

Hi Moorthy,

"lost" => In the SXMB_MONI I can see the Dynamic Configuration segment in the SOAP Header before the message in transfered to the BPM. After the BPM the SOAP Header doesn't contain any Dynamic Configuration Segment.

If there is no transformation step executed inside the BPM the Dynamic Configuration is not lost.

I'm asking myself if it is not related to the fact that the mappings in the BPM are not executed on the same runtime, so the header is initilized again.

Thanks,

Bela