BPM SXI_Cache: RC99 - Send step: Property exception for...

[Former Member]

Hi Folks,

I configured the File => RFC => File scenario like in /people/arpit.seth/blog/2005/06/27/rfc-scenario-using-bpm--starter-kit .

In SXI_Cache the BPM hAs Returncode 99 and I get the following error-messeges after repeating activation:

W : Send step: Property exception for '9C42FE40FAE211DACF11F3A4C0A80038' is missing

and

E : Send step: Fault message 'f1163bd3fae211dabb8df3a4c0a80038' is not defined

I defined a standard fault-message therefore I'm not sure where's the problem... any advise?

thx in advance

Martin

Edit: SAPKB64017 installed.

[former_member187339 · Accepted solution]

Hi,

Click F7 on the BPM. Are you getting any errors?

Regrads

Suraj

[Former Member · Accepted solution]

Hi Suraj,

thx for your answer. F7 in Integration Builder => "No errors found"

Martin

[former_member187339 · Accepted solution]

Hi,

Refer this thread:

Regards

Suraj

[moorthy]

Hi,

I think, problem with Fault Messages used in the Send Step properties. CHeck this correctly..

Also try to activate the BPM once again and check SAP note -708338

Do you have container variable for the Fault messages type..

REgards,

Moorthy

[Former Member]

Hi Moorthy,

> I think, problem with Fault Messages used in the Send

> Step properties. Check this correctly..

I created a new Fault Message, changed nothing and used it in the abstract message interface definition. Using this abstract message interface in the send step causes XI to insert the corresponding fault message in the send step automatically . Not sure if I have to made any changes to the FMT?!

> Also try to activate the BPM once again and check SAP

> note -708338

Reactiving doesn't helpes

> Do you have container variable for the Fault messages

> type..

AFAIK it isn't possible to create a container of type "fault message" or to define an abstract "fault message"... ?!

> REgards,

> Moorthy

Martin

Message was edited by: Martin Sliwka

[moorthy]

Hi Martin,

It is better to reimport the BPM in the configuration and run the interface. Then go to SXI_CACHE and check the status against IP..

Also try to refresh the cache in the directory.

Regards,

Moorthy

[Former Member]

Hi Folks,

I deleted the BPM in the configuration, imported it again and refreshed directory cache. Anyway, I stil get the same property exception and fault message errors....

Martin