on 02-23-2010 7:02 AM
Hello,
we are using GRC 5.3 SP 8.1.
User default mappings with more than one "role" attribute and the condition "OR" don't seem to work. After provisioning no user parameters have changed in backend system. When I configure only one "role" with the condition "AND" everything works fine, request types are the same.
Any suggestions?
Thanks,
Manuel
Hi Manuel,
User Default Mapping issue was identified in AC 5.3 SP 8.1 and is fixed in SP11.
Refere to fixes of SP11 in Note # 1168508.
Best Regards,
Sirish Gullapalli.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hallo Sirish,
thanks for this helpful answer.
In the note it says: "After upgrade from 5.2 to 5.3 SP08.1, the user defaults were not provisioned."
So this error only occurs when upgraded from 5.2 to 5.3 SP8.1 or is it a gnerally bug in SP 8.1?
I configured some new conditions in our test system and it worked. So in my opinion only the old configured user default mappings don't work because of the upgrade (???). I'm a little bit confused...
Regards,
Manuel Kunkel
Hello Manuel,
We are on 8.1 and did not upgrade from 5.2. (had a clean install of 5.3). We still have the user default errors so I don't think it's just limited to upgrades.
Thanks,
Peggy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.