TMS problem with ECC 6.0

[Former Member]

Dear Global Support,

After hardware resizing we have successfully installed ECC 6.0 and

successfully performed DB restoration.

Now the problem lies with TMS as after installation performing necessary post installtion activity

we have configured TMS. As per all TMS check STMS configuration is fine. Even tp and domain

profile are generated.

But issues lies while releasing change request as after realease no data or cofile are populated in 
trans/data or trans/cofile.

Even slog is not been generated. Kindly look into this and advice the needful.

Regards,

Partha

[Former Member]

Thanks Paul

[paul_power]

Hi Partha,

Is there only one system in the transport landscape at present?

If the transport has been built up in STMS properly, there should be no problem to export.

But you can create a virtual system and create the "transport route" accordingly.

Then when you release a transport, the data and cofiles should be generated.

Is the transport a local transport?

Do you get a message "LOCAL REQUEST .......... released(objects no longer locked) "

Local request can not be transported so releasing a local request does

not export file to operating level.

If you want to transport this released local change request, you

can create a new reqeust of tranport type "Transport of Copies" from

SE01 and include the objects in <local transport number>.

Then you can transport the content of <local transport> by this newly created

request.

Hope this helps,

Paul

[Former Member]

Thanks Paul,

You are correct. I was so silly.

Thanks again