Sender RFC Issue

[Former Member]

Hi All,

I have an RFC-XI-File Scenario which is working fine in dev and qa. After moving to Pre-Prod, I see the inbound XML's do not have all the values. I debugged the program before the RFC call in R/3 and I see all the values. However when it come to XI there are only few values getting populated.

I have restarted the channels but no luck.

Please note that the scenario is working in Dev and QA and the IR objects / and ID objects are like.

Please suggest solution

Regards

Unni

[former_member200962 · Accepted solution]

However when it come to XI there are only few values getting populated.

XI (normally) wont modify the input payload (unless mapping logic is applied).....are you able to see the entire message content in the log of your Communication Channel?

Also there should not be any version conflict between the RFC in the SAP system and the RFC in XI/ PI

Regards,

Abhishek.

[Former Member]

Issue was in the RFC connection, it should have been unicode.

Regards

Unni