Addition of New KF in SNP PA (SCM 7.0)

[Former Member]

Dear All,

When we need to add a new key figure in SNP planning are we need to deactivate the planning area, add the new key figure and activate the planning area. But I heard that in SCM 7.0 we can add the new key figures without deactivating the planning area. Please let me know is that possible? If so how can I do it?

Thanks,

Siva.

[Former Member · Accepted solution]

Hi Siva,

In transaction /sapapo/msdp_admin, select the planning area

and right click on it, and click on change key figure settings,

then it will take you to change mode, wherein you need to go

to append mode and do the changes.

I would suggest, please carry out the changes in testing

environment and test thoroughly and if successful, transport

the changes to production environment to avoid any com

errors or loss of data

Regards

R. Senthil mareeswaran.

[Former Member · Accepted solution]

Hi Senthil,

Thanks for your reply.

I hope the steps what you have mentioned is applicable only for time series key figure.

Becuase after adding a keyfigure in the planning area I was trying to change the Semantics from '000' to '001' but failed.

So pelase confirm whether we can add the order series keyfigure without deactivating the planning area.

Thanks,

Siva.

[former_member583013 · Accepted solution]

Hi Siva,

No,you can't change keyfigure Semantics from '000' to '001' once planning area is initialized.

To add keyfigure in SNP planing area and to change keyfigure semantics you have to de-initialize the planning area and then change.Please note that de-intialize planning will delete all time series planning data.

Regards,

Sunitha