Data is not going from merep_10700 table to outbox

[former_member459142]

Hi experts,

After distribution data is in merep_10700 but not going in device and in outbox,

can you please tell me why .

Thanks

Prashnat

[Former Member · Accepted solution]

Hi,

if you say you distributet data into MEREP_10700 - hasve you done that manually or was it done by an MI job?

If it was done by an MI job, it should be on the device already - in my understanding.

Regards,

Oliver

[former_member459142 · Accepted solution]

Hi Oliver,

Thanks for reply,

I run 'MEREP_DISTRIBUTOR' THEN data goes in MEREP_10700 but when i will see in MEREP_MON then no data shows in outbox.

then i Sync the device, data doesn't come.

Thanks

Prashant Gupta

[Former Member · Accepted solution]

Hi,

okay - but as it stays in 10700 it should be seen as well in MEREP_MON and on device. Based on the rule it has to come down? What is the exact configuration and what is the setup of the BO? Furthermore what is the businesscase?

As well: do you run MEREP_MON with any limitations? Can you see the device sync request going through MEREP_MON?

Regards,

Oliver