on 02-02-2010 6:43 AM
HI Frnz
i done a scenario and is running successfully. but the problem is in inbound queue. i am getting the status ready here. if activate the queues then only the message is successfully delivering to the target system.
every time i need to activate the queues. how to over come this.
Thanks
Munna
Hi Munna,
U have to register the queues,Pls do the following steps.
1)Go to SXMB_ADM
2)Select Manage Queues
3)Select REgister Quesues
4)Select Activate Queues
Then automatically all jobs are successfully sent to u r Target system.
Thanks
Ravi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Some messages are getting stuck in status RUNNING on only 1 specific queue (that sends message to ECC).
I'm planning to schedule a JOB to execute RSQIWKEX if this queue is in status RUNNING for more than 5 minutes (the process shouldn't take more than 1).
Therefore, If I run RSQIWKEX, the queue is set to status READY and doen't start automatically (the queue was registered before running RSQIWKEX. Do I need to register again?)
Is there a program that registers a queue automatically so I can run after RSQIWKEX?
Thanks.
At.,
Bernardo Tavares Braga
Hi,
activate the queues in SXMB_ADM - queue registration
and then it should work
let me know if it did
Regards,
Michal Krawczyk
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.