on 01-29-2010 3:58 PM
Hello.
I am trying to print a standard label from SAP. The label was desinged using Zebra Bar-One V5.0.
When I load the Zebra Code to a SAPScript using the SO10 Transaction and then perform a test print, the printer only prints the Zebra Code as uploded, it doesn't intepretate it.
This is the code I am uploding through the SO10:
^XA
^PRC
LH0,0FS
^LL280
^MD0
^MNY
LH0,0FS
FO196,23A0N,31,28CI13FRFDALMACEN DE REPUESTOS CARACASFS
FO120,77A0N,27,23CI13FRFD83.03.518FS
FO40,108A0N,27,23CI13FRFDDescrp:FS
FO40,140A0N,27,23CI13FRFDUbicac:FS
FO40,172A0N,27,23CI13FRFDOrden:FS
FO40,204A0N,27,23CI13FRFDProvee:FS
FO478,172A0N,27,23CI13FRFDRecepcion:FS
FO40,236A0N,27,23CI13FRFDCantid:FS
FO40,77A0N,27,25CI13FRFDCodigo:FS
FO121,108A0N,27,23CI13FRFDAMORTIGUADOR 2516001002FS
FO120,140A0N,27,23CI13FRFDAMORT27FS
FO120,172A0N,27,23CI13FRFD4900014796FS
FO120,204A0N,27,23CI13FRFDG.D Societa Per AzioniFS
FO147,236A0N,27,23CI13FRFD1FS
FO591,172A0N,27,23CI13FRFD03.11.2009FS
FO478,77A0N,27,23CI13FRFD499846FS
^PQ1,0,0,N
^XZ
^FX End of job
^XA
^IDR:ID.
^XZ
If I print the label format directly from the Zebra Bar One Program, the label is printed pefectly.
Can any one give a hint about what is happening ?
Thanks for you support.
Regards.
First thing is to check that the spool is correct.
Then make sure that what goes outside SAP is correct: you may debug the output device (SPAD transaction), by selecting either log or retain print file (see forum or sap documentation for more information).
If it's correct then maybe that the default emulation is not correct on the printer (check it on the control panel)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.