on 01-27-2010 2:03 PM
Hello,
We have a PI Netweaver 7.0 system running for the past 6 months.
Is there any way to find out whether the 'Configuration Wizard' was executed successfully and completely on the system after the installation?
The Installation doc says that -
You can run the Configuration Wizard only once and only directly after you installed and patched the system.
So I can't even run it again now.
Hello
You can manually check/complete the configuration by following the steps in the link below:
Wizard-Based Basic Configuration
http://help.sap.com/saphelp_nw70/helpdata/en/a0/40084136b5f423e10000000a155106/frameset.htm
You can then do a system health check by following the steps in this note - #817920 XI Readiness Check.
Regards
Mark
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.