Inspection plan

[Former Member]

Gurus,

Whenever i create a Qplan the system is always showing a warning msg stating that the

Task list contains Error.

What should be done to avoid this warning.

[former_member42744 · Accepted solution]

This can often be cause by using the same characteristic in multiple operations. That's not unusal to do in many industries and I wish SAP would come up with a way to turn off that particular warning in the task list check.

Craig

[Former Member]

Hi

Mainly this error is due to control indicators you select

like

1.you have ticked "Inspec tool" & not assigned same.

2.you have not assigned upper lower unit of measurement or decimal places for Quantitative data.

3.you have ticked on the "Defect rec" in control indicator but you have not entered defect codes in the task list.

Regards

Sujit

[Former Member]

Hii,

Check ur Inspection plan for

1. Check whether u have assigned correct MIC's . (For ex Inspection point, SPC criteria)

2. Check for Sampling procedure is assigned w.r.t to MIC's,

3. Check for Proper usage u have assigned.

In all the above cases if any parameters is missing w.r.t other master data system will throw a warning & error message.

with regards,

K.Lokesh.