on 01-25-2010 1:21 PM
Hello every one,
I had an issue regarding inspection characteristics in an inspection plans.
I am trying to specify the upper limit and lower limit of a specific quantitative characteristic in an inspection plan. But when i am doing so the system does'nt allow me to specify the control limits in decimal places.
How do i allow the system to accept decimal / floating point values for a specific inspection characteristic in an inspection plan?
Thanks in advance.
Sincerely,
Aji
How many decimals is the characteristic set up for? How many are you trying to use in your upper and lower spec?
You can't specify more decimals in the upper and lower specs, then what is alowed by the characteristic.
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.