cancel
Showing results for 
Search instead for 
Did you mean: 

Inspection Lot with Zero stock posting qty

anand_rao3
Active Contributor
0 Kudos

Dear QM Consultants,

We have come across following scenario,

1. Repetitive manufacturing

2. Material has inspection type 04 and Z04. Preferred inspection type is not ticked. Z04 inspection type has been assigned to inspection lot 04.

3. Production GR done by 131 movement

4. Inspection lot generated with reference to 131 movement type. Lot for inspection type 04 is created.

5. Inspection lot qty in QA32 it shows correctly as that of GR qty.

6. But when we click on UD, in stock posting tab, qty to be posted it shows as ZERO. So no qty is available for stock posting.

Has anybody came across such scenario? Is this any bug? Any SAP note for this?

Best Regards,

Anand Rao

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi

Check in MMBE Or MB51 where the stock is .Is it in QI or Unrestricted.

As per my knowledge it will be in unrestricted.Have you ticked on Post to Inspection in QM view( in 04 inspection type & not Z04).

Regards

Sujit

anand_rao3
Active Contributor
0 Kudos

Dear Sujit, Thanks for so prompt reply,

Basically this is a complex case,

1. See we have set Posting Proposal in Usage Decision as u2018To unrestricted useu2019 in selected sets for usage decision. That means we need not every time go to stock posting tab. The moment we select ACC UD code it automatically posts the stock to unrestricted use.

2. Now, what has happed, by 131 movement declaration, backflush happened with 261 movement for child parts.

3. Inspection lots with inspection type 04 were created. (Here we did not note whether the stock was posted in quality inspection or in unrestricted use)

4. Now the requirement is to cancel 131 movement document. Kindly note UD were not given up to this moment.

5. Now through MFBF, user did document specific reversal. As a result of which and as per my knowledge 132 movement should happen and 262 should also happen. At the same time inspection lot status should be set to LTCA. But in actual case 132 movement happened and 262 did not. Surprisingly inspection lot did not set to LTCA status. It remained in REL mode only.

6. After this document specific reversal, user gave UD to these inspection lots without noticing where the stock was lying.(in unrestricted or in quality inspection). So the lot status set to UD ICCO SPCO STUP after giving usage decision.

7. Now while doing reverse engineering that why 262 movement did not happen, we came to know that no 321 movement happened for the inspection lots which were generated with reference 131 movement document

8. Also, qty to be posted it shows ZERO as explained in my earlier post.

9. When we display 132 movement document through MIGO, in where tab it shows stock type as Quality inspection. That means stock was lifted from QI for 132 movement.

In short it cannot be predicted where the stock was actually posted whether in QI or in unrestricted use. But yes the post to inspection stock tick has been ticked in material master.

Can you help further in this regard?

Best Regards

Anand Rao

Former Member
0 Kudos

It's Indeed a very complex scenario.

Now you can not reverse the documents by QI as SAP note is not applied to the REM scenario.

Only way is try to cancel the document specific reversal.

or

Forcefully reverse the backflush ( reverse MB21-->261) for child components aganist planned order

Regards

Sujit

anand_rao3
Active Contributor
0 Kudos

Thank you Sujit.

Answers (0)