on 01-20-2010 7:55 PM
Gurus,
When i am trying to record results for Inprocess inspection,i getting a message stating
NO characterstics found
In QA32 it is not allowing to calculate the sample & the calci symbol is in display mode.
Hi
first check the the in QA02>inspection spec>is task list assigned here.?
now check in sample tab ,is sample calculated.?
What is status of the inspection lot.?
if task list & sample size is calculated then status will become "CALC"
Also in Inspection set up you must tick on "check char" for result recording.
If you have used Inspection points then you must assign sampling procedure( with inspection point) against each char.
then only sample size will be caluculated.
I hope trhis will add some value
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
What is the status of the lot?
Vishal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
What is the status of the lot,
Vishal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please check your Sapling procedure assigned .
Sampling procedure should be created using inspection points free inspection point and assign that in Routing MICs
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.