Problems in CUA..

[Former Member]

Hello,

We are facing some problems with CUA setup.

Last week we removed a child system from CUA and changed its SID and now we are trying to add the system into CUA.

When the system is added through SCUA in Central system it goes fine without a single error, but the system is not found in SCUA list in child system. Also when we add the system with new SID in central system, it shows the old SID and not the new SID

under SAP Systems column.

We are able to transfer users from Central system but not able to modify users from Central system.

All steps were followed as per SAP docs when deleting the child system from CUA.

Could someone share your thoughts/ideas on the above problem.

Thanking you in advance.

Regards,

Yoganand.V

[Former Member]

if you run RSDELCUA in test-mode on your master and child system, what does it say?

[Former Member]

Hello,

Child system was deleted as per SAP docs. Why do I need to run RSDELCUA in child system?

The point I forgot to say is the system we copied (the old system) is still active in the landscape but not

connected to CUA. CUA is our SOLMAN system were we have SLD running, is this causing CUA to read the old systems

data. The new system is not added to SLD yet.

Please share your thoughts.

Regards,

Yoganand.V

[Former Member]

Hi,

Check the below configuration to check the child system.

1.Check the RFC connection are proper or not.

2. Logical system entry for system.

3. Check the RFC status for child system in CUA.

4. Also check the user mentioned in RFC , This user should not be locked and have proper authorization.

[Former Member]

Hai,

We are able to add the correct system in CUA now, but we tested with a test user transfer from CUA to target system.

User got transferred correctly and when we tried to add a role to the test user from CUA, the role is not reflecting in child system.

No IDOCS blocked, no errors but still not changes in child system.

Any ideas?

Regards,

Yoganand.V

[Former Member]

Run the text comparison for new system in CUA. And after that check the inbound queue in child system in BD87 for USERCLONE message type idocs.If idoc is stucked in inbound queue. Check the error message and do accordingly. Also check the user groups in child system. These should be synchronized with CUA.

Also transfer the address and user from SCUG.

Hope this helps.

[Former Member]

Try to check on SCUL for the respective user. If the distribution succeed, it will be highlighted in green, else something's wrong with your CUA model.

What is your output mode for CUA idoc related?

Check both settings on central and child system.

Check BD87 on central and child system for the related idoc.

No Idocs blocked does not mean the idoc successfully posted.