IDOC Sender Adapter acknoledgements

[Former Member]

Hi,

we have a scenario IDOC -> PI => HTTP Plain (ASync) .

I have configured the Message Type ALEAUD and AUD1 in sender system.

I also have the ACK_SYSTEM_FAILURE = 1

Now , when I get a permanent error from the HTTP receiver adapter. The acknolegement message falls in error .

The message says that the Receiver component (HTTP system) canot be converted into an ALE logical system.

What is missing... I thought we didn't have to define the external system anywhere except as a Business Component in Integration Builder ... ?

Thanks.

[udo_martens · Accepted solution]

Hi Thierry,

i assume your http receiver business system is missing a logical system name. You should add it in SLD, delete the BS in IB Directory (do not activate) and reimport it from SLD. Then activate.

You can control that under "Adapter specific Identifier" of the BS in IB Directory.

Regards,

Udo

[Former Member · Accepted solution]

Hi Theirry,

You open the Integration Directory and under "Adapter specific Identifier" of the Business System, and add Logical System, R/3 System ID and Client properly. This should be for BS which is the sender of IDocs.

Regards,

Sugata Basu

[Former Member · Accepted solution]

Hi,

thanks... it worked, now the ALEAUD IDOC is sent back to ERP but the status of the outbound IDOC is not changed.

In fact in WE02 on ERP , the message is that the EDI interchange accord is not created for the thirds party's logical system (that's the one that had the http error) ...

Now , since I'm planning to have possible 50 third party systems, I'm hoping we don't have to define a accord for each third party.

Can't it just be set to some generic value ??? or done more elegantly ... I thought this should be a lot simpler to maintain.

Thanks.

[RaghuVamseedhar]

Hi,

To suppress acknowledgement there should be entry of idoc type in table IDXNOALE, to add entry run this program IDX_NOALE

http://help.sap.com/saphelp_nw04/helpdata/en/44/932e8896b610bbe10000000a422035/frameset.htm

[MichalKrawczyk]

Hi,

I'd propose my book :

http://www.sap-press.com/product.cfm?account=&product=H3059

for ALEAUD configuration with screens and to understand different types of it's usage

Regards,

Michal Krawczyk

[Former Member]

Hi Michal , I have your book. Its quite good . I will try adding the BS in sld to see if it solves the problem...

Perhaps you can add this to next edition if it was the problem.

Thanks.