on 01-08-2010 3:52 PM
Hi
I have the below error in the CC,we are sending X12 EDI file to SAP PI (EDI X12->PI->SAP) using sender file adapter and using modules like classifier,bic,splitter.Can you please let me know why did error occurs.
Error: Error in Adapter call failed. -module:MessageSplitter failed. MESSAGESPLITTER:No configuration found for the source file ************|TM_E2X_ANSIX12_997_allVersions|ACCEPTED|1. Please make sure you have configured <Sender>|<MappingName>|<ACCEPTED> in the module configuration or you have used BIC, split is enabled and corresponding splitting configuration is configured in the splitter frontend.
Make sure that you have done the required configuration at message splitter of seeburger workbench.
You have to do entries like Sender party||mapping name || sender agreement etc...
Refer the standard seeburger documentation for more details
Regards
Sunil.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi.. normally the seeburger documents will be available as the part the installation.
You will not find any link for this documentation.
We have already a lot of blogs written on seeburger, but in my opinion the best think for you to get the documents and read them..as the are precise and only documented the steps and procedures which needs to be done as the part of configuration.
Regards
Sunil.
If you can search you will find a number of blogs which will give you more idea on the product and its components.
like
For more information you can go to:
/people/dijesh.tanna/blog/2008/05/25/sap-pixi-content-conversion-using-generator-mapping-functionality-of-seeburger-part-1
/people/prateek.srivastava3/blog/2009/08/01/seeburger--part-1--the-basics
/people/rajeshkumar.pasupula/blog/2009/08/05/wanna-implement-seeburger-for-edi-find-the-booster
Edited by: Sunil John on Jan 8, 2010 10:29 PM
Hi,
This error occured as there is no configuration found for the partner for that message in the seeburger message splitter...
i.e after BIC mapping and during the execution of the splititng the payload splitter tries to find the Key(PartnerNo <sender>|| MessageType <Seeburger Mapping Name>|| Accepted or Partial accepted....) if the configuration related to this key not found in Message Splitter tab of seeburger workbench then you will get the above error...
solution is to go to seeburger workbench and configure the partner configuration along with message type...
if need more details about this check the below blog of mine...
/people/rajeshkumar.pasupula/blog/2009/08/05/wanna-implement-seeburger-for-edi-find-the-booster
HTH
Rajesh
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.