on 01-06-2010 5:34 AM
Gurus,
How sampling inspection can be handled in SAP.
What are the steps to achieve this?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I am getting this error,
Diagnosis
There is no inspection point type for physical samples entered in the task list header.
However, this inspection point type is a prerequisite for inspection lot origin "15".
System Response
The system could not complete the creation of the inspection lot.
Procedure
1. In the task list header, enter the inspection point type for physical samples.
2. To correct the error in the inspection lot, choose Change inspection lot and trigger the task list selection and sample calculation again.
i have defined freely defined inspection point(100) in QP01
HI,
Repeatedly i getting the same error
You cannot record any characteristic results for this inspection lot. The material master has been set up for the existing inspection type in such a way that results recording is not supported.
for any kind of inspection
What criteria is missing in material master?
User | Count |
---|---|
98 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.