on 12-28-2009 6:12 PM
Hi,
Is there a way to transfer data from Seeburger to ECC 6.0 via RFC, Web Service or any other method without having to go to PI? All the conversions will be done in Seeburger.
Thank you.
hi ,
Are you talking about EAI tool of SEEBURGER ?
If yes than sure...we can
check out .....http://www.seeburger.com/products/
Regards ,
Edited by: Santosh Rawat on Dec 29, 2009 10:11 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You can use Seeburger BIS as standalone application. You need to configure the Seeburger BIS adapters are X.400, some ALE configuration for IDoc and you need to create the Work Flow. All the conversion of mapping done in Seeburger BIC so you can create the Seeburger BIC mapping using Seeburger BIC MD. In this case no need to connect to PI system, Seeburger BIS is act as EAI tool.
Regards,
Ramesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
You seem to have posted the same thread multiple times. please close one of them.
Regards
Monika
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
well.... , in that case you have to post your thread in other forum than PI !!!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.