Copy results for inspection points

[Former Member]

Hi Gurus,

I am using copy inspection result function for inspection point. I have defined machine & mould as identifiers for inspection point.When i try to copy results from inspection points some times results get copied. But sometimes results dont get copied.Sometimes results get copied but they are in closed status. In copy inspection results setting in Customization i have not activated the check box for close. i also maintain different identifiers for whom results to be copied & from whom to be copied.What might be reason.

Regards

Amit

[Former Member · Accepted solution]

Hii,

Check the following settings,

In SPRO copy,

Inspection type - --

controls in inspection lot - 3 manulal & auto data

control in RR - 3 manula & auto data

Origin TL -4

Data orig no -4

Selection - 300

mapping - 300

In inspection plan of charcteristic screen of general data maintain the Origin RR as " from Inspection point"

Check it & revert back

with regards,

K.Lokesh.

[Former Member · Accepted solution]

Dear Lokesh,

Thanks for your quick reply. The settings u have mentioned are already in place. What i have decided is to keep only one identifier. It is working properly.

Regards

Amit

[Former Member]

Problem Solved

Regards

Amit