Inspection lot qualtity

[Former Member]

Hi,

I am using source inspection for Quality check. Now the scneraio is as follows:

I created one PO with one line item and quality 100. After PO creation i go to QI07 and created a manual inspection lot. I do the result recording , UD etc. And if the UD is accepted i am ablee to do the MIGO and if the UD is rejected error is there durig MIGO.

Now the issue is if out of 100 quantities in PO only 20 are not ok and rest 80 are ok. Is it possibel to record it in inspecction so that i can do migo for 80 numbers of material and send 20 to vendor. Because in present sccneraio all the lot has been accepted or rejected. Can i devide the lot on the baiss of ok and not ok.

[former_member186399]

Hello

This is not possible using source inspection. you can control the quantity in only GR inspection

Regards

Gajesh