on 12-02-2009 12:28 AM
dear all,
I try to install the add on to netweaver, and the netweaver is download from SDN 7.0 SR3
and after I load the SAR file to the system, start the installation.
but for the fisrt step, it check the system requirment,
it give the error: TP_CANNOT_CONNECT_SYSTEM
and return code:0208
could someone give some support?
thanks
I feel it's a STMS configuration issue. What's the result of the checks , i mean
STMS -> System Overview -> Select the corresponding system -> SAP System -> Check
Do the all there checks under that,
Connection test
Tranport directory
Transport tool
Regards
Jose
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Run R3trans -d and check if everything is OK. If not then check trans.log in same directory from where you will run R3trans -d.
Also, have you followed installation guide to install netweaver SR3 ?
BI Cont you can install once you will finish the installation from SAINT.
Thanks
Sunny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Alex,
Have you configured the STMS in the system. Before applying support patches or add-on, configure the STMS. SInce it is single system make it as a domain controller and after that start installing the add on. Configure STMS from 000 client.
Also, you have uncar the sar file before installing the add-on. You can do this manually at OS level using SAPCAR -xvf <filename> and then put the two files .ATT and .PAT files in EPS\IN folder and after that load it from SAINT. Other way is you can place the file on your desktop and load packges from front end in SAINT.
Thanks & Regards,
Sharath
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.